HARDINFO
HardInfo is a system profiler and benchmark for Linux systems. It is able to
obtain information from both hardware and basic software, and organize it
in a simple to use GUI.
Features include:
- Report generation (in either HTML or plain text)
- Benchmark result synchronization
- Ability to explore the information on remote computers
Status
Capabilities: HardInfo currently detects most software and hardware detected by the OS.
Features: The remote sync was disabled due to server loss.
Development: Currently done by contributors, a new dedicated maintainer is needed.
DEPENDENCIES
Required:
- GTK+ 2.10 (or newer)
- GLib 2.10 (or newer)
- Zlib (for zlib benchmark)
Optional (for synchronization/remote):
- Libsoup 2.24 (or newer)
BUILDING
Create a build directory and build from there:
hardinfo $ mkdir build
hardinfo $ cd build
build $ cmake ..
build $ make
There are some variables that can be changed:
CMAKE_BUILD_TYPE: Can either beReleaseorDebug.[Default: Release]Debugprints messages to console and is not recommended for general use.
CMAKE_INSTALL_PREFIX: Sets the installation prefix.[Default: /usr/local]: Distributions usually change this to/usr.
HARDINFO_NOSYNC: Disables network synchronization.[Default: 1]: Disabled by default due to the server being lost.
To set a variable, use cmake's -D parameter. For example:
build $ cmake .. -DCMAKE_BUILD_TYPE=Debug
Network sync is enabled if libsoup is detected. If having trouble building with libsoup, disable it with:
build $ cmake -DHARDINFO_NOSYNC=1
SETTING UP
Most hardware is detected automatically by HardInfo, however, some hardware
needs manual set up. They are:
Sensors
lm-sensors: If your computer is compatible with lm-sensors module, use by example the
sensors-detect program included with the lm-sensors package of Debian based distros, and be sure
to have the detected kernel modules loaded.
hddtemp: To obtain the hard disk drive temperature, be sure to run hddtemp
in daemon mode, using the default port.
Memory Speed
The module eeprom must be loaded to display info about your currently installed memory.
Load with modprobe eeprom and refresh the module screen.